Vorige Omhoog Volgende

The Classic PACTOR® Controller
PTC-IIpro

  • PACTOR-II & PACTOR-III•
  • Real multi port unit
  • Low power consumption
  • GPS interface for NMEA data

• PACTOR-III is optional (20 Connections). For a permanent use you need a valid license!  

The PACTOR-II protocol is essentially based on the Level-I standard, consisting of a synchronous half-duplex ARQ protocol. New, however, is the ability to choose four different speed steps, so that a greatly improved adaptability is obtained.

The ultimate HF modem! Fast, full featured and upgradable to PACTOR-III. Send email, transfer files, establish real-time data links. The PTC-IIpro modem is the multi mode data interface between your PC and radio equipment. The PACTOR-II mode is the industry standard, and the most robust digital mode available for radio data connections. The PTC-IIpro will maintain links in conditions with signal to noise ratios of minus 18 dB, transferring data with absolutely inaudible signals.

The PTC-IIpro comes standard with 2 MB of RAM for incoming data storage, integrated RS-232 and TTL interface for control of common radios and a temperature compensated crystal oscillator for stability. The PTC-IIpro incorporates an audio amplifier for output to a speaker or headphones, which allows the PTC-IIpro's powerful DSP to be used with any audio signal. Built-in ability for GPS position reporting. With the optional Packet-Radio modules, the PTC-IIpro will function as a VHF/UHF modem (up to 19200 baud) and act as a bidirectional gateway for data between HF and VHF/UHF radios.

Easily installed with compatible radios from Icom, Kenwood, Yaesu, SGC, SEA, Furuno, R&S and others. Use the PTC-IIpro with commercial stations worldwide or the international network of Winlink amateur radio operators that support PACTOR-II and PACTOR-III.

Technical Data

Audo input impedance: 47 kΩ
Audio input level: 10 mVp-p - 2 Vp-p
Audio output impedance: 1 kΩ
Audio output level: max. 3 Vp-p adjustable in 1 mV steps
Audio processing: Digital Signal Processor DSP56303 / 100 MHz 768 kByte additional DSP RAM
FSK output: TTL levels, high - Mark, low - Space
Serial interface: Sub-D 9 (AT type) 2400 - 115200 Baud
Processor: Motorola MC68360, 32 Bit CMOS CPU 25 MHz
RAM: static 2 MByte, CMOS, battery buffered
Realtime clock: Date and time
Front panel: 10 char. LED dot matrix display 30 LED's split into various functional groups
Rear panel: Power switch, sockets for transceiver connection, socket for the serial interface (RS232)
Power Supply: 10 - 20 V DC, 500 mA max., reverse polarity protected, self resetting fuse
Dimensions: Width 172 x Height 43 x Depth 205 mm
Weight: 765 g
Operating temperature: -10 to +50 °C

Standard Accessories

Modem, Power Connector, RS232 cable, Audio cable, Control cable, CD-ROM, Installation Guide .

zie ook: http://www.scs-ptc.com/controller.html